PB Series Niche LED Colour Changing Pool Light
Lights: 72 LEDs, 19 modes
Voltage: 12V AC
Maximum Current: 550ma
(0.55A)
PHYSICAL SPECIFICATION
Diameter: 115mm
Other Properties:
U.V. Resistant A.B.S. Casing
Polycarbonate lens, 316 Stainless Screws
OPERATING INSTRUCTIONS
SINGLE LIGHT
To change the colour mode of the light, switch the power to the light ON and OFF. The light must be switched back on within 10 seconds or the light will default to its original mode.
TWO OR MORE LIGHTS
(Note: Lights running in sequence must use a common power switch.)
To synchronise the colour changing the following operation must occur - the power to lights must be switched ON and OFF three times (within 10 seconds each time).
These LED lights must be connected to a 12 volt AC, 50 Hz supply (Supplied Separately)
Each light contains 72 LEDs and requires a maximum of 0.55 amps.
Our lights have two special features, they constantly check and regulate the voltage being supplied, they also have a built in temperature sensor which regulates the temperature within the lamp housing should the need arise.
We reserve the right to change the modes in this light at our discretion.
Manufacturers WARRANTY
The warranty does not apply to failure occurred due to abuse, misuse, incorrect installation or incorrect voltage connection, a 12V AC transformer must be used.
The warranty period will commence on the date of the original purchase. The buyer/user must present proof of purchase when claiming repairs under warranty. Returning the light to the dealer will be at the owner’s expense.
